General Safety Regulations - Genius RAINBOW 324 C Guía Para El Instalador

Carefully read the instructions before using the product.
Store these instructions for future reference.
Thank you for choosing our product. GENIUS is sure you will get the
performances you expect to satisfy your requirements.
the automated systems, strengthened by being part of a world leading
group in this sector.
The automated systems of the RAINBOW family are electro-mechanical
barriers which have been designed and realised to control vehicle
accesses.
During design particular attention has been paid to the many installation
requirements. The result has been a product attentive to installer
ergonomy, the control unit is located on the upper part of the automated
system and can be rotated. Attention has also been paid to the ease of
installation: suitable facilities for the photocells and the key-selector are
present on the housing. Both on the housing and on the rods you can
Thanks to the various types of rods available, these can be used in very
different types of accesses, from a minimum of 3 meters to a maximum
of 7 meters in case of single applications.
These automated systems consist of a steel structure with powder paint
enclosing the non-reversing electro-mechanical gearmotor.
A handy release device, protected by customised key, enables you to
move the rod by hand in the event of a power cut.
Thanks to the use of 24V motors and of the encoder (standard supplied),
all automated systems of the RAINBOW family are able to guarantee
very high safety levels. If correctly installed, they realise installations in
compliance with current safety standards.

GENERAL SAFETY REGULATIONS

If correctly installed and used, the RAINBOW automated system
guarantees a high level of safety. Certain simple rules of behaviour can
also avoid accidental hitches:
Do not transit when the rod is moving. Transit is only allowed when the
beam is completely open.
Do not in any way stand under the rod.
Keep radio controls or any other pulse generators out of reach of
children, to prevent the automated system from being activated
involuntarily.
Do not allow children to play with the automated system.
Do not willingly impede the movement of the rod.
Prevent any branches or shrubs from interfering with the movement
of the rod.
Do not attempt to manually move the rod unless you have released it.
In the event of malfunctions, cut power, release the rod to permit access
Once the system has been set in manual mode, before restoring normal
operation check that the system is not powered.
system.
Have the efficiency of the automated system checked every six
months.
Do not attempt any kind of repair or direct action whatsoever; these
by GENIUS service centres.
Make sure that the installing techni ci an fills out the enclosed
maintenance register
MANUAL OPERATION
If a manual operation of the rod is necessary due to a fault of the
automated system or to a power cut, operate as follows:
Cut power to the system using the differential switch upstream
of the system.
Insert the key into the release device and turn it clockwise until it stops,
.
.
.
RESTORING NORMAL OPERATION
To prevent an involuntary pulse from activating the automated
system, make sure the system is not powered up using
the differential switch, before restoring normal operation
mode.
Turn the release device counter-clockwise until it stops, Fig. 2 ref.
Turn the key counter-
2 ref .
Power up the system.
MAINTENANCE
To ensure a correct operation and a constant safety level over time
perform, every six months, a general check of the system paying special
attention to the safety devices. The booklet "Instructions for use" contains
a form for the registration of the maintenance operations.
personnel or by GENIUS service centres.
REPAIRS
The user must not attempt any repair or job and must only and exclusively
Page 3
Fig. 1
.
.
Fig. 2