DeWalt DE2000 Manual Del Usuario página 33

The thrust block (89) ensures your workpiece is always guided to the
correct side of the cutter.
When edge moulding
• Mount the copy follower bearing off-centre to the cutter.
• Make the cut where the widest part of the cutter is exposed.
• Set the tip of the thrust block at a tangent to the cutting point.
• Ensure that the arm and the thrust block knobs are fully tightened.
• With the router OFF, move your workpiece in the desired manner,
to make sure that all points can be moulded as required.
• Switch the Combi-Table ON and proceed in the usual way.
Using templates
• Position the ball bearing over the cutter, making sure the centre of the
two are in line.
• Prepare a template. The difference between bearing and cutter
diameter corresponds to the difference between workpiece and
template dimensions.
• Secure the template to the workpiece using double-sided tape.
• With the router OFF, move your workpiece in the desired manner,
to make sure that all points can be moulded as required.
For the correct position of the ball bearing (91), refer to fig. M4:
• A Edge moulding with bearing off-centre.
• B Trimming facing material flush to edge of workpiece with a
trimming cutter.
• C Edge moulding following template contour.
Mounting the dust extraction set (DE2005) (fig. A2 - A3)
The dust extraction set has two hoses: one is to be connected to the
Power Tool and the other one to the dust spout on the Combi-Table
(DE2011: on the saw blade guard [25]; DE2000: on the router fence [29]).
A dust hose support (DE2006) is available as an option.
• Slide the dust extraction hose over the dust spout (24 or 33).
Consult your dealer for further information on the appropriate accessories.
Maintenance
Your D WALT attachment has been designed to operate over a long
E
period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
• Replace the cutting insert when worn out.
Cleaning
Regularly clean the attachment with a soft cloth.
Unwanted products and the environment
Take your attachment to an authorized D
be disposed of in an environmentally safe way.
25
WALT repair agent where it will
E
GUARANTEE
• 30 DAY NO RISK SATISFACTION GUARANTEE •
If you are not completely satisfied with the performance of your
D WALT tool, simply return it within 30 days, complete as purchased,
E
to a participating Dealer, or an authorized D
full refund or exchange. Proof of purchase must be produced.
• ONE YEAR FREE SERVICE CONTRACT •
If you need maintenance or service for your D
12 months following purchase, it will be undertaken free of charge at
an authorized D WALT repair agent. Proof of purchase must be
E
produced. Includes labour and spare parts for the attachments.
Excludes accessories.
• ONE YEAR FULL WARRANTY •
If your D WALT product becomes defective due to faulty materials or
E
workmanship within 12 months from the date of purchase, we
guarantee to replace all defective parts free of charge or, at our
discretion, replace the unit free of charge provided that:
• The product has not been misused.
• Repairs have not been attempted by unauthorized persons.
• Proof of purchase date is produced.
This guarantee is offered as an extra benefit and is additional to
consumers statutory rights.
For the location of your nearest authorized D
please use the appropriate telephone number on the back of this
manual.
E N G L I S H
WALT repair agent, for a
E
WALT tool, in the
E
WALT repair agent,
E
en - 8