Panasonic CS-V12CTP Instrucciones De Operación página 5

NAME OF EACH PART
■ Remote Control
1
2
AUTO
HEAT
COOL
H
DRY OFF OFF ON ON OFF OFF ON ON
A B
3
TEMP OFF/ON
MODE SLEEP FAN SPEED
4
5
A B
6
TIMER AIR SWING
7
SELECT SET/CANCEL MANUAL
RESET
● Remote Control Signal.
• Make sure it is not obstructed.
• Maximum distance : 10 m.
• Signal received sound.
One short beep or one long beep.
● Notes for Remote Control.
• Do not throw or drop.
• Do not get it wet.
• Certain type of fluorescent lamps may affect
signal reception. Consult your dealer.
● Do not place the remote control in a location exposed
to direct sunlight, or next to a heating unit, or other
heat source.
12CTP5-01EN(01-09) 4
1 Signal Transmitter
2 Operation Display
Cooling Model
FAN AN
SPEED SPEED
AUTO
COOL
H
DRY
FAN OFF
8
Heat Pump Model
9
AUTO
!
AUTO
"
HEAT
#
COOL
DRY
OFF
$
3 Room Temperature Setting Button
(Illuminating button)
4 Operation Mode Selection Button
5 Sleep Mode Operation Button
(Illuminating button)
6 Timer Setting Button
7 Timer Selection Button
8 OFF/ON Button
(Illuminating button)
9 Fan Speed Selection Button
0 Auto Airflow Direction Button
! Timer Set/Cancel Button
@ Manual Airflow Direction Selection Button
# Reset Point
(Press with fine-tipped object to clear the memory)
FAN
SPEED
H H
ON OFF ON
A B
FAN
SPEED
H H
ON OFF ON
A B
12/24/09, 11:29 AM
● How to Insert the Batteries
2
1
1
Gently press the place marked OPEN and slide
the cover towards you.
2
Insert the batteries
– Be sure the direction is correct.
● About the batteries
• Can be used for approximately one year.
● Observe the following when replacing the batteries
• Replace with new batteries of the same type.
• Do not use rechargeable batteries (Ni-Cd).
• Remove the batteries if the unit is not going to be
used for a long period.
● Proper way to operate the remote control in the
case of ceiling/wall mounting.
• Operate the remote control in parallel with the floor.
(See the figure below)
(Fig. 1) Horizontal Level
• The signal changes as shown in the figure below.
It means that the receiving conditions are bad and
the signal can not be controlled properly.
(Fig. 2)
O.K.
OUT
4