Error Codes - LaserLiner DistanceMaster Pocket Pro Manual De Instrucciones

Technical Data
Inside measurement range
Precision (typical)*
Laser class
Laser wavelength
Power supply
Dimensions (W x H x D)
Weight (incl. batteries)
Automatic switch-off
Operating temperature
Storage temperature
Article number
* measuring distance up to 10 m with strongly reflective target surface
and at room temperature. The measurement deviation may increase by
± 0.2 mm/m for greater distances and under unfavourable measuring
conditions such as strong sunlight or weakly reflective target surfaces.

Error codes:

Err101: Replace the battery
Err104: Calculation error
Err152: Temperature is too high
Err154: Temperature is too low
Err155: Received signal too weak
Err156: Received signal too strong
Err157: Incorrect measurement or background is too bright
Err160: The device is moving too much to measure.
EU directives and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be
collected separately for disposal according to
the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
DistanceMaster Pocket Pro
(Subject to technical changes without notice 11.12)
0,05 m - 50 m
± 2 mm
2 < 1 mW
650 nm
2 x AAA 1.5 Volt batteries
48 x 112 x 24 mm
106 g
28 sec laser / 3 min device
-10°C – 40°C
-20°C – 70°C
080.948A
17
GB