Belkin F1DL102P Manual De Instrucciones página 3

P74416ea_F1DL102P_QIG.qxd 2/24/04
Introduction
This sheet will guide you through the basic steps needed to install the 2-
Port KVM Switch with Audio Support and Built-In Cabling (the Switch). If
you have any problems during installation, please refer to the User Manual.
Port Status
Indicator LEDs
Console
Speaker Jack
Console
Mouse Port
Console VGA
Monitor Port
Console
Keyboard Port
You will need the following items to install the Switch:
• 2-Port KVM Switch with Audio Support and Built-In Cabling
• One (each) keyboard, monitor, and mouse
• Speakers and mic (optional)
2:51 PM Page 2
Built-In Cables
Console
Mic Jack
1
Connecting the Keyboard, Video, and
Mouse to the Console Ports on the Switch
1. Power down all computers.
2. Connect your PS/2-type keyboard and mouse to the purple keyboard
and green mouse ports located on the front panel of your Switch.
3. Take the video cable that is attached to your monitor and connect it to
the VGA port on the front panel of your Switch.