Dash Disassembly; Kit Assembly; Din Radio Provision With Pocket - Metra 99-8225G Manual De Instrucciones

Toyota Venza 2009-up
1. Unclip and remove the
trim panel to the right of
the shifter. (Figure A)
2. Remove (1) Phillips screw
from the bottom of the
climate control then
unclip and remove the
climate control. (Figure B)
3. Remove (4)10 mm bolts
securing the radio.
(Figure A)
Note: You will need a
universal swivel head
socket adapter to get
to the bottom left bolt.
(Figure C)
4. Remove (4) Phillips
screws securing the
factory radio to the A/C
vent panel. (Figure D)
Continue to kit assembly
(Figure B)

Dash Disassembly

(Figure C)
(Figure D)

DIN radio provision with pocket

1. Locate the factory
2. Secure the radio
Rear view - Radio and A/C
vent panel
3. Slide the DIN cage
REAR VIEW - RADIO AND A/C VENT PANEL
Radio
RADIO
2

Kit Assembly

wiring harness in
the dash. Metra
recommends using the
proper mating adapter
from Metra or AXXESS.
Re-connect the negative
battery terminal and
test the radio for
proper operation.
(Figure A)
housing into the factory
A/C vent panel using
the factory hardware.
(Figure A)
into the radio housing
and secure by bending
the metal locking tabs
down. (Figure B)
(Figure B)
Rear view - A/C vent panel
REAR VIEW - A/C VENT PANEL