Dash Disassembly; Kit Preparation - Metra 99-7526B Instrucciones De Instalación

DASH DISASSEMBLY

1. Unclip and remove the dashboard trim
panel above the glovebox. This panel
will also include the middle a/c vents.
(Figure A)
2. Remove (1) 10mm screw securing the
radio, then unclip, unplug, and remove
the radio. (Figure B)
Continue to Kit Preparation
2
(Figure A)
(Figure B)

KIT PREPARATION

1. Secure the radio support bracket to
the sub-dash using the factory 10mm
screw removed in dash disassembly.
Directly above this is the factory radio
support brace. Bend this towards the
front of the vehicle to allow room for the
aftermarket radio. (Figure A)
2. Remove the panel clips from the factory
radio, then attach them onto the radio
housing base. (Figure B)
3. Clip the radio housing base to the dash.
(Figure C)
Continue to Kit Assembly
(Figure A)
(Figure B)
(Figure C)
|
386.257.1187 MetraOnline.com