Dash Disassembly - Metra 95-93078 Manual Del Usuario

1. Remove the volume knob by pulling
out towards the rear of the vehicle.
2. Turn the exposed screw 90º using
a T-10 Torx screwdriver, pull out
on the bottom of the radio, then
unplug and remove the lower
portion of the radio. (Figure A)
Note: Leave the Torx driver in place
to aid in pulling out the radio.
3. Remove the (2) T-10 Torx screws
securing the top portion of the
radio, then unplug and remove the
radio. (Figure B)
4. Unclip and remove the wood trim
panels above the glove box, and to
the left of the radio. (Figure C)

Dash Disassembly

5. Remove the (1) Phillips screw
securing each side panel on the
center console, and then slide
the panels forward to unclip and
remove them. (Figure D)
6. Open the glove box, and then
unclip and remove the glove box
side supports. (Figure E)
Continued on the next page
(Figure A)
95-9307B
(Figure B)
(Figure C)
2
(Figure D)
(Figure E)