Iso Din Radio Provision With Pocket - Metra 99-8225G Manual De Instrucciones

DIN radio provision with pocket
4. Slide the aftermarket
radio into the cage and
secure. (Figure C)
5. Snap the factory vent
panel/radio housing over
dash cavity. (Figure D)
6. Reassemble remaining
radio and dash
assemblies in reverse
order of disassembly.
(Figure A) (Figure B)
Kit Assembly

ISO DIN radio provision with pocket

1. Locate the factory wiring
harness in the dash. Metra
recommends using the
proper mating adapter from
Metra or AXXESS. Re-connect
the negative battery terminal
and test the radio for
proper operation.
2. Secure the radio housing into
the factory A/C vent panel
using the factory hardware.
(Figure A)
3. Mount the ISO brackets to
the radio with the screws
supplied with the radio.
(Figure B)
4. Slide the radio into the radio
opening until the side clips
engage. (Figure C)
5. Snap the Trim Plate into the
radio housing. (Figure C)
6. Snap the factory vent panel/
radio housing over dash
cavity. (Figure D)
7. Reassemble remaining radio
and dash assemblies in
reverse order of disassembly.
3
Rear view - A/C
vent panel
REAR VIEW - A/C VENT PANEL
(Figure A)
(Figure B)
Right side
clip
(Figure C)
(Figure D)