teutonia Fun System Manual De Instrucciones página 12

INT
FUN SYSTEM
Swivel wheel
Swivel wheel unlocked
We recommend that you do not lock the wheels while
moving as this will give a more comfortable ride.
Seat cover
The seat cover can be completely removed from the seat
unit in order to be washed. To do this, press the press studs
on the seat unit.
The middle seat or reclining surface is designed as a
two-way seat. Release the side zips, pull the cover over at
the head end and the belt on the other side and
re- attach the centre piece on the sides.
Attention: When fitting the seat cover, please pull the end
of the 5-point harness back through the matching openings
without twisting it.
Height-Adjustable, Foldable Handle
Applying the Parking Brake
wheel rim. Make sure that the brake has locked securely.
You can release the brake by depressing the brake lever 2.
12
Swivel wheel locked
To change the height of the
handle, press in the adjusting
buttons on both sides of the
handle.
The brake is activated by push-
ing down the long brake lever
1. If it is difficult
apply the brake, wheel the
stroller back and forth a few
centimetres so that the brake
bars engage properly in the
Attaching and removing the sports buggy seat or
carry-cot (upper section)
Place the upper section (sports buggy seat or carry-cot)
onto the pram chassis in such a way that the lateral bars 1
of the upper section click into the slots provided 2 on each
side of the chassis and push the upper section in as far as
it will go. The locks then close automatically. (The locks
must "click" into place.)
WARNING:
Check that the pram body or seat unit attach-
ment devices are correctly engaged before use.
The upper section is secure if the red field in the release
lever is no longer visible. To remove the upper section press
the safety lever (3) up and then the release lever (4) down
until the lever locks. (red field appears). Then pull the upper
section out of the slots and remove it.
How to use the hood
Push the insert pieces for the hood joints into the corres-
ponding openings on the armrest or on the carry-cot.
Attention: You must secure the press studs on the back
end of the cover onto the rear of the backrest as the cover
is also used as a protection against falling out.
If you need to remove the hood, undo the press studs on
the rear of the backrest; press the release buttons on the
insert pieces of the hood joints and pull the joints out of the
openings. You can open the zip at the top of the hood for
ventilation.
Adjusting the Backrest
to
Pull the grip 1 upwards and
move the backrest 2 into the
required position.
make sure that the backrest
re-engages properly.
Please