Kingfisher KI 9600 Serie Guía De Referencia Rápida página 2

Quick Reference Guide – KI 9600 Optical Power Meter
 To remove interchangeable connector adaptor, press the
button on the front of the instrument and pull off adaptor.
 To defeat auto power-off, press and hold [POWER] for 3
seconds during turn on. 'Perm' is displayed on the top right
of the LCD.
 Low battery is indicated with a battery symbol.
 During instrument turn on:
to view all display segments, press and hold []
-
to turn buzzer off, press and hold []
-
to display firmware version, press and hold [HOLD]
-
to start Slow mode, press and hold [dB/dBm/mW
-
Set Ref]
 To scroll wavelength, press [] or [].
 To toggle logarithmic/relative/linear display modes, press
[dB/dBm/mW].
 To stop / start display update, press [HOLD].
 To set reference, press and hold [Set Ref] for more than 3
sec. When in reference mode, the reference value is
shown on the left hand side of the display.
 To display max min recorded power, press and hold [Max
Min]. To re-set this function, press [Max Min].
Revision 2 3Sep2013
Page 1 / 14
KINGFISHER INTERNATIONAL

When multi-fibre ID tone is detected by a power
meter, a buzzer will sound and the corresponding
fiber ID number will be displayed. This function is
disabled in SlowMode,

When a standard tone is detected (eg 270 Hz, 1 KHz,
2 KHz), a buzzer will sound and the corresponding
modulation frequency will be displayed.

If the meter detects a test tone higher than 200 Hz,
the display will show the actual measured modulation
frequency in kHz. This function is disabled in
SlowMode.
English