Kingfisher KI 9600 Serie Guía De Referencia Rápida página 3

Quick Reference Guide – KI 9600 Optical Power Meter
SlowMode:

In SlowMode, the display will show average optical power
of the modulated signal. All tone detection is disabled.

To start SlowMode, press and hold [dB/dBm/mW Set Ref]
while turning power meter on. "- tonE" will be displayed.

To start SlowMode when power meter is already turned
on, press and hold [], then press [dB/dBm/mW Set
Ref]. "- tonE" will be displayed.

To start SlowMode when test tone detection is active,
press [dB/dBm/mW Set Ref].

While SlowMode is on, alternating "" and "B" symbols
will be displayed.

To exit SlowMode, press and hold [], then press
[dB/dBm/mW Set Ref].
Turning power meter off will end Slow Mode.
TamperLock Mode:

While in TamperLock Mode, user is prevented from
changing wavelength, dB/dBm/mW, Hold, min max and
SlowMode settings.
Revision 2 3Sep2013
Page 2 / 14

To start TamperLock Mode, press and hold [], then
press and hold [HOLD].
When display show "codE", enter six key sequence.
Triple beep will be heard and display will briefly show
"LOut" to indicate completion.

While TamperLock is active, "<<<" and ">>>" symbols
will be displayed.

If power meter had been locked while in dB R mode,
press and hold [Set Ref] to set reference.

To clear TamperLock, hold [] and [HOLD] while
turning power meter on.
When display show "codE", enter six key sequence. If
the correct sequence had been entered, "PASS" will be
displayed indicating that TamperLock had been cleared.

In case where entered sequence was not correct, "FAIL
x" will be displayed (where x is attempt count)

TamperLock will be cleared after three unsuccessful
attempts.