Important Safety Instructions; General Safety - Eco-Flo EFSUB5-102-1 Manual Del Usuario

Important Safety Instructions

Carefully read and follow all safety instructions in
this manual and on pump.
SAVE THESE INSTRUCTIONS – This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the
product. Save this manual for future reference.
Safety Labels
This is the safety alert symbol. When you see
this symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury!
Indicates a hazard which, if not
avoided, will result in death or serious injury.
Indicates a hazard which, if not
avoided, could result in death or serious injury.
Indicates a hazard which, if not
avoided, could result in minor or moderate injury.
NOTICE
indicates practices not related to
personal injury.
Keep safety labels in good condition. Replace missing
or damaged safety labels.
Under certain conditions,
submersible pumps can develop extremely high
pressure. Install a pressure relief valve capable of
passing entire pump flow at 100 PSI
(690 kPa).
Do not allow pump, pressure
tank, piping or any other system
HAZARDOUS PRESSURE
component containing water to freeze. Freezing may
damage system, leading to injury or flooding. Allowing
pump or system components to freeze will void
warranty.
Can shock, burn or cause death.
To avoid dangerous or fatal
HAZARDOUS VOLTAGE
electric shock hazard, use pump only in a water well.
For parts or assistance, call ECO-FLO Customer Service at 1-877-326-3561

GENERAL SAFETY

Do not install this pump in a pond, river or other open
body of water that could be used for swimming or
recreation. Do not swim, wade or play in a body of
water in which a submersible pump has been installed.
according to local and Canadian Electrical Code or
National Electrical Code requirements that apply.
supply before installing or servicing pump.
pump voltage and frequency.
Install pump according to all plumbing, pump
and well code requirements.
Test well water for purity before using well.
Call your local health department for testing
procedure.
During installation, keep well covered to prevent leaves
and foreign material from falling into the well. Foreign
objects in well can contaminate water and cause
serious mechanical damage to pump.
Pipe joint compound can cause cracking in plastics.
Use only teflon tape when sealing joints in plastic pipe
or connecting pipe to thermoplastic pumps.
4
Install ground and wire pump
Disconnect electrical power
Make sure line voltage matches