Setup And Connections - marklin Start up 72752 Manual De Instrucciones

5. Setup and Connections

Setup may be done only under the supervision of adults.
Unplug the switched mode power pack from the household
current in order to prevent damage during setup. Do not plug
the switched mode power pack in the wall outlet again until
you are finished with all of the wiring.
• Plug the cable that comes with the signal control box into
the 4-pin socket (left or right) (see Fig. 1 that follows)..
• After that, insert the other plug into the 4-pin socket on
the 253391/322979 Base Station (see Fig. 1 that follows).
!
The cable that comes with the signal control box may not
be altered.
The 71054 connecting cable must be used to extend this
connecting cable (not included with the signal control box).
Fig.2
253391
322979
4


72751/72752
1
Fig.1
253391
322979
2
You can connect this control box to the free 4-pin socket of
an existing 72751 or 72752 control box (see Fig. 2).

2
72752
72752/72751
3
1
9