Marshall MIDANC Manual De Instrucciones página 5

Tabla de contenido

Publicidad

LEGAL NOTICE
Marshall is a trademark of Marshall Amplification Plc. Permission granted. Design
of product and packaging are intellectual properties of Zound Industries International AB.
© Zound Industries International AB. All Rights Reserved.
The Bluetooth® wordmark and logos are registered trademarks owned by the Bluetooth SIG,
Inc. and any use of such marks by Zound Industries International AB is under license.
Siri and macOS are trademarks of Apple Inc., registered in the U.S. and other countries.
IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and
is used under license.
Qualcomm aptX is a product of Qualcomm Technologies International, Ltd. Qualcomm is a
trademark of Qualcomm Incorporated, registered in the United States and other countries,
used with permission.aptX is a trademark of Qualcomm Technologies International, Ltd.,
registered in the United States and other countries, used with permission.
Zound Industries International AB, Centralplan 15 111 20 Stockholm, Sweden
www.marshallheadphones.com
FCC WARNING
FCC ID is located under the right ear cushion. To remove, hold ear cushion and turn
counter-clockwise.
Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation. This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This device must not be co-located or operating in conjunc-
tion with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The device must not be co-located or operating in conjunction
with any other antenna or transmitter.
IFETEL
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible
que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o
dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su
operación no deseada.
ANATEL
Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra
interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a
sistemas operando em caráter primário.
O USO PROLONGADO DESTE APARELHO EM ALTO VOLUME NAO E RECOMEDADO.
Nos termos da Lei 11,291/06, o usuário fica advertido de que a utilização deste aparelho em
volume superior à 85 decibéis poderá acarretar danos a seus sistema auditivo.
O carregamento deste produto deve ser feito somente na entrada USB de um computador.
IC WARNING
IC ID is located under the right ear cushion. To remove, hold ear cushion and turn
counter-clockwise.
Les numéros d'identification IC ID est situés juste sous le coussinet d'oreillette droit.
Pour l'enlever, maintenez le coussinet d'oreillette et tournez dans le sens inverse des
aiguilles d'une montre.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil est conforme à la norme RSS sans licence d'Industrie Canada. Son
fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas
provoquer d'interférence et (2) cet appareil doit supporter les interférences, y compris
les interférences susceptibles de provoquer un fonctionnement inattendu.
This device complies with the RF exposure limits for an uncontrolled environment set
forth by Industry Canada. Canadian information on RF exposure and compliance can be
obtained from Industry Canada.
Cet appareil est conforme aux réglementations d'Industrie Canada concernant les
limites d'expositions aux radiofréquences dans un environnement non contrôlé. Les
informations sur l'exposition aux RF et de conformité pour le Canada peuvent être
obtenues auprès d'Industrie Canada.
This Class B digital device complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme ICES-003 au Canada.
CAN ICES-3 (B)/NMB-3(B)
低功率電波輻射性電機管理辦法
第十二條經型式認證合格之低功率射頻電機,非經許可 ,公司、 商號或使用者均不得擅自變更
頻率、 加大功率或變更原設計之特性及功能。
第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時 ,應
立即停用,並應改善至無干擾時方得繼續使用。 前項合法通信,指依電信法規定作業之無線電
通信。 低功率射頻電機須忍受合法通信或工業、 科學及醫療用電波輻射性電機設備之干擾。

Publicidad

Tabla de contenido
loading

Tabla de contenido