Automatically Set; Default Setting - Beta 1760DGT/2 Manual De Usuario

Automatically set

Auto set is one of the advantages digital oscilloscopes have. When you push the Auto
button, the oscilloscope will identify the type of waveform (sine or square wave) and adjust
controls according to input signals so that it can accurately display the waveform of the
input signal.
Functions
Cursor
Display Format
Horizontal Position
SEC/DIV
Trigger Level
Trigger Mode
Trigger Source
Trigger Slope
Trigger Type
Vertical Bandwidth
Vertical Coupling
VOLTS/DIV
The Auto function examines all channels for signals and displays corresponding
waveforms. Auto determines the trigger source according to the following conditions.
 If multiply channels get signals, the oscilloscope will use the channel with the lowest
frequency signal as the trigger source.
 If no signals are found, the oscilloscope will use the lowest-numbered channel displayed
in Auto Scale as the trigger source.
 If no signals are found and no channels are displayed, the oscilloscope will display and
use Channel 1 as the trigger source.

Default Setting

Long press button, enter Short key setting menu, and select Default. Press
button, pops up the prompt to recall the default settings on the screen, now press F1 to
confirm. The oscilloscope will display the CH1 waveform and remove all the others. Press
F4 to cancel. The table below gives the options, buttons and controls that change settings
at default setup.
Menu or
System
Cursor
Settings
Off
Set to YT
Adjusted
Adjusted
Set to 50%
Auto
Adjusted
Adjusted
Edge
Full
Unchanged
Adjusted
Option, Button or
Knob
Type
Source
Horizontal
Default
Setting
Off
CH1
±4div
60