MN006555A01.book Page 16 Wednesday, July 29, 2020 2:09 PM
Internal Voice Operated Transmission/
Voice Operated Transmission (
Transmission is initiated by speaking into the
microphone of the radio/audio accessory instead of
pushing the PTT button.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most
environments
L1 = Low Sensitivity for noisy environments
1. Press
Menu until the
display. When audio accessory is connected, the
icon is shown. The current setting (Off, L1–L3) flashes.
2. Press
or
to select the sensitivity level.
3. Press the PTT button to exit menu or
continue set up.
When using iVOX/VOX, there will be a short
Note:
delay.
Dual Watch Mode
Enables you to scan the current channel and
another channel alternately.
To set another channel and start Dual Watch.
16
1. Press
/
)
2. Press
3. Press
4. Press the PTT button or wait until the time out to activate
5. To end Dual Watch mode, Press
Note:
Keypad Tones
icon appears on the
You may enable or disable the speaker key tones.
You hear the key tone each time a button is pushed.
1. Press
Menu to
2. Press either
3. Press the PTT button to confirm and exit Menu or
Note:
•
•
•
Menu/Lock until
flashes.
or
to select the channel, then press
or
to select the code.
Dual Watch. The screen alternates between Home
Channel and Dual Watch Channel.
If you set the same channel and code as
current channel, Dual Watch does not work.
Menu/Lock button until
current setting On/Off flashes.
or
to turn On or Off.
Menu/Lock button to continue set up.
When the keypad tone feature is off, the
following are not disabled:
Transmit timeout alert tone
Call tone
Low battery alert tone or
appears. The
.
icon.
appears. The