Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Press the PTT button to save the code setting and exit
Menu or
Menu/Lock button to continue set up.
You can set a different code for each channel using
this procedure.
On a radio that uses Interference Eliminator
Note:
Codes, the code must be set to 0 to
communicate with radios that do not have
Interference Eliminator Codes. Select 0 for "no
tone, no code" on the display of your radio.
Setting and Transmitting Call Tones
Your radio can transmit different call tones to other
radios in your group so you can alert them that you
want to talk. Your radio has 20 call tones from which
to choose.
To set a call tone:
1. Press
Menu/Lock until
tone setting flashes.
2. Press
or
to change and hear the call tone.
3. Press the PTT button to set the new call tone and exit
Menu or
Menu/Lock button to continue set up.
To transmit your call tone to other radios set up to
the same channel and Interference Eliminator Code
on your radio, and press
Setting the call tone to 0 disables the call tone
Note:
feature.
16
appears. The current call
Call Tone button.
Internal Voice Operated Transmission/
Voice Operated Transmission (
Transmission is initiated by speaking into the
microphone of the radio/audio accessory instead of
pushing the PTT button.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most
environments
L1 = Low Sensitivity for noisy environments
1. Press
Menu until the
display. When audio accessory is connected, the
icon is shown. The current setting (Off, L1–L3) flashes.
2. Press
or
to select the sensitivity level.
3. Press the PTT button to exit menu or
continue set up.
When using iVOX/VOX, there will be a short
Note:
delay.
Dual Watch Mode
Enables you to scan the current channel and
another channel alternately.
To set another channel and start Dual Watch.
/
)
icon appears on the
Menu to
Publicidad
Tabla de contenido
