Care Instructions; Spare Parts - Rosenbauer HEROS-xtreme Manual Del Usuario

Rosenbauer - User Guide HEROS-xtreme
4.5 Visor
The integrated visor is attached to the
front edge of the helmet and should be
pulled down until it locks. The visor is
pushed up in the reverse sequence, but is
first secure when tangible locking occurs.
The optional eye protection visor is pulled
down until it locks using both lateral levers
simultaneously. It is pushed up in the reverse sequence, but is first secure when
tangible locking occurs.
WARNING: The protective function of the visor and the protective
goggles is ensured only in the end position (final stop, no intermediate
position). Improper use of the visors can lead to serious injury or even
death. Damaged visors may no longer be used and must be replaced
immediately.

5. Care instructions

The outer layer of the helmet, the plastic parts and the inner lining must be
cleaned periodically. It is best if the outer layer of the helmet is cleaned after
every operation; this reduces the ability of the dirt to stick. Clean the outer
layer of the helmet and the plastic parts solely with water, a mild plastics
cleaner or dishwashing liquid, and a soft cloth.
Rinse visors with water before cleaning and clean them using a mild
dishwashing liquid or similar and a soft cloth.
CAUTION: Do not use any abrasive sponges or similar!
WARNING: Never clean any part of the helmet or visor with solvents,
petrol, acids, etc., as this can have negative effects on the protective
function.
5.1 Cleaning of the headband cover
In order to secure a certain degree of operational hygiene, cleaning of the
headband cover is recommended as required. In the textile version, the head-
band must be removed from the helmet as described in Section 4.1.3 and the
cover taken off the headband by opening up the Velcro fastening. Both textile
components can be washed in a washing machine at 40°C.
34 34
If the headband cover is leather, clean it by wiping the band with a cloth
moistened with suitable material; leather parts must not be washed.
During reassembly of the textile components, care must be taken that when
closing the Velcro fastening, the join points towards the helmet and is therefore
not visible from the outside. Subsequently, the headband is reinserted into the
helmet using the reversed removal procedure.
5.2 Chinstrap cleaning
The chinstrap should be cleaned as
required. It is recommended that the
Velcro fastening on the head strap (below
the head net) be opened fully.
Subsequently, the two screws (hexagonal
socket) on the lateral chinstrap
anchorage are to be loosened.
Following the opening of both short neck straps (adjacent to the adjustment
mechanism), the chinstrap can be slipped out and then washed in a washing
machine at 40°C.
During reassembly, it is recommended
that the head strap be inserted first. The
two neck straps should then be fixed and
the lateral screws mounted. Finally, the
chinstrap should be adjusted to the ideal
position as described in Section 4.1.4.

6. Spare parts

All spare parts can be simply exchanged.
Face protection visor, clear
Face protection visor, gold
Eye protection visor, clear
Eye protection visor, tinted
Front mask
Headband with cloth cover
Cloth cover for headband
Inner lining (complete)
Chin strap
User Guide HEROS-xtreme - Rosenbauer
156850
156851
156854
15685403
156857
156859
15687001
156863
156870
GB
35 35