Rosenbauer HEROS-xtreme Manual Del Usuario página 19

Rosenbauer - User Guide HEROS-xtreme
7. Checks and servicing
The completeness, secure anchorage and functionality of the helmet
components should be ensured following every cleaning operation and
component substitution. In addition, a visual check for damage must be
completed. Should damage have occurred, this is to be corrected by a specialist
immediately, - otherwise the helmet should be returned to the manufacturer for
examination.
Duration of use of the HEROS-xtreme:
The duration of use of this helmet is affected by the material types used in
its construction as well as the environments in which the helmet is used and
stored.
Recommendations of the manufacturer:
The maximum period for the use of helmets depends strongly on their wear,
such as the effects of weather, thermal and mechanical stress, etc. All fire
fighting helmets of the HEROS-xtreme series have excellent ageing resistance,
assuming that they are used properly.
As a rule, the helmet, the inner lining and the accessories should be inspected
for damage before and after every operation. If the helmet or parts thereof are
damaged, they may no longer be used. For safety reasons, the helmet may also
no longer be used after being impacted or subjected to unusual stress such as
a strong collision or other forces.
To achieve a period of use that is as long as possible, the regulations and
information listed in the user information MUST be observed. In particular, the
helmet should be cleaned appropriately after every use (see item 5) and should
be stored so that it is protected against sunlight and moisture. We recommend
a maximum duration of use of 15 years for fire fighting helmets of the HEROS-
xtreme series if they are used, cared for, maintained and stored properly
Service life of / inspecting fire fighting helmets
7.1 General
As a general principle, the instructions and rules in the user information
provided with every helmet supplied to the customer apply.
It is important to strictly observe all the instructions in the user information to
ensure user safety.
Rosenbauer accepts no liability for damage caused by failure to observe the
user information and individual items of the user information.
36 36
7.2 Inspection
As a rule, the helmet, the interior trim and the accessories should be inspected
for signs of damage before and after every operation. You must not use a
damaged helmet or damaged helmet parts; defective parts must be replaced
immediately.
After each operation where the helmet has been exposed to unusual stress (e.g.
impact, knocks, dropping, other types of force, direct exposure to flame, high
and/or extended exposure to heat, exposure to chemicals, contact with molten
metal and others), all helmet components must be carefully inspected before
redeploying the helmet.
This check must be performed by a suitably trained member of staff; note that
Rosenbauer offers appropriate staff training.
All helmet components must be inspected carefully and damaged parts must be
renewed without exception before the helmet is reused.
We recommend performing this check every 2 years and logging the inspection
and replacement of helmet components.
Never use a damaged helmet, it might not provide the protection you expect!
Helmet components must immediately be replaced by original parts if one of
the following criteria applies, or other visible damage exists:
Helmet shell + visor
a) Cracks of any kind
b) Missing components
c) Grooves or scratches deeper than 1mm
d) Blistering
e) Major surface damage due to excessive heat or flame exposure
f) Substantial damage to the protective coating
g) Damage to individual components
Interior trim, chin strap, neck protection
a) Cracks of any kind
b) Missing components
c) Damage, lack of robustness, inclusions
d) Damage to textile components due
to cuts, tears, wear, fraying or similar
e) Damage to seams
f) Damage to Velcro fasteners
g) Major discoloration of components
h) Damage to individual components
User Guide HEROS-xtreme - Rosenbauer
GB
37 37