PAREO
Release the transporting catch.
1
Unfold the chair.
2
Completely secure the chair by pressing the rear pedal as far as it will go.
3
To recline the backrest, activate the mechanisms situated on both sides of the chair.
4
5
Fit or remove the hoods using the flange at the end of the hood arch.
Make the hood taut by tightening the side compasses.
6
To raise or lower the footrest use the mechanisms situated underneath it.
7
To fit the rain cover, don't forget to pass the upper buttonholes over the three handles.
8
To fold the chair first raise the lower rear compass as shown in the photo.
9
After the rear compass, press the side compass.
10
To secure the child in the harness, push clips (A) and (B) into the buckle housing (C) until they
11
snap into position. Carefully adjust the harness by pulling the slider (D) until the desired fit is
achieved across the lap, shoulders and between the legs.
To release the buckle, squeeze the top and bottom clips until it disengages.
CAUTION: Always adjust the harness when changing the seating position of the child.
WARNING Always use the crotch strap between the legs in combination with the lap strap.
Start to fold the chair pushing the handlebar forwards.
12
Fasten the chair with the transporting catch.
13
MAINTENANCE
Do not expose the cover to sunlight for long periods.
Wash the plastic parts with warm water and soap and carefully dry all the components after.
C
M
Y
CM
MY
CY CMY
6
K
11