EN
1
DESCRIPTION
1.1
PURPOSE
This machine is used to remove and clear away snow from
pavements, gardens, driveways and other ground-level
surfaces.
1.2
OVERVIEW
Figure 1
Safety key
1
Bail switch
2
Chute deflector
3
Discharge chute
4
Battery compartment
5
Impeller
6
Scraper
7
Wheel
8
Middle handle
9
Carrying or lifting handle
10
Upper handle
11
Chute control rod
12
Lower handle
13
LED light
14
Knob
15
Bolt
16
Keyed hole
17
Latching tab
18
Slot
19
Post
20
Coupling hole
21
Battery pack
22
Upper chute control rod
23
Lower chute control rod
24
Spring pin
25
Screw
26
Mounting screw
27
Side wear pad
28
Nut
29
Belt
30
Pulley
31
2
SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
WARNING
English
3
INSTALLATION
Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until you
assemble all the parts.
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
•
If the parts are damaged, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2
INSTALL THE UPPER HANDLE
Figure 2
1. Align the holes in the middle handle and the upper
handle.
2. Put the bolts through the holes.
3. Tighten the handle knobs onto the bolts.
4. Do the same operation on the other side.
3.3
INSTALL THE MIDDLE HANDLE
Figure 2
1. Align the holes in the middle handle and the lower
handle.
2. Put the bolts through the holes.
3. Tighten the handle knobs onto the bolts.
4. Do the same operation on the other side.
3.4
INSTALL THE CHUTE
DEFLECTOR
Figure 3
4
WARNING
WARNING
WARNING
WARNING