Troubleshooting; Technical Data; Warranty; Ec Declaration Of Conformity - GreenWorks SNF402 Manual Del Operario

• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
6

TROUBLESHOOTING

Problem Possible cause
The handle is not The bolts are not
in position. engaged correctly.
The machine does The battery ca-
not start. pacity is low.
The battery pack is
too cold.
The battery pack is
not attached to the
engine.
The bail switch is
defective.
The engine barely The impeller or
rotates. discharge chute is
blocked or dam-
aged.
The capacitor is
defective.
Excessive vibra- There are loosen
tions parts.
The impeller or
engine is dam-
aged.
The engine is on, The belt is dam-
but the impeller aged.
does not turn.
A thin layer of The scraper is
snow stays behind. damaged.
English
* If you cannot find the solution to these problems, go to the
service center.
7
Voltage
No load speed
Clearing width
Clearing depth
Weight (without battery
pack)
Measured sound pressure
Solution
level
Adjust the height
Guaranteed sound power lev-
of the handle and
el
make sure that the
Vibration
knobs and bolts
are aligned cor-
Battery model
rectly.
Charger model
Charge the battery
pack.
Charge the battery
8
pack in the warm
area for 15 mi-
(The full warranty terms and conditions can be found on
nutes.
Greenworks webpage)
Check the connec-
The Greenworks warranty is 3 years on the product, and 2
tion between the
years on batteries (consumer/private usage) from the date of
engine connector
purchase. This warranty covers manufacturing faults. A faulty
and the battery
product under warranty might be either repaired or replaced.
pack.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
Replace the bail
warranty. Normal wear, and wear parts are not considered as
switch, or speak to
warranty. The original manufacturer warranty is not affected
the service center.
by any additional warranty offered by a dealer or retailer.
1. Clean the im-
A faulty product must be returned to the point of purchase in
peller and dis-
order to claim for warranty, together with the proof of
charge chute.
purchase (receipt).
2. Replace the
impeller.
9
Speak to the serv-
ice center.
Name and address of the manufacturer:
Tighten correctly
all the fasteners
Name:
and caps.
Replace the dam-
Address:
aged parts.
Name and address of the person authorised to compile the
Replace the belt.
technical file:
Name:
Replace the scra-
Address:
per.
7

TECHNICAL DATA

40 V
1900 ± 10% / min
50.8 cm
25.4 cm
17.2 kg
68 dB(A), K
96 dB(A)
< 2.5 m/s
G40B4 and other BAF series
G40UC and other CAF ser-
ies

WARRANTY

EC DECLARATION OF
CONFORMITY
GLOBGRO AB
Globe Group Europe
Riggaregatan 53, 211 13 Malmö, Sweden
Peter Söderström
Riggaregatan 53, 211 13 Malmö, Sweden
EN
= 3 dB(A)
pA
2 2
, K = 1.5 m/s