Technical Data - Flo 79510 Manual De Instrucciones

SPECIFICATION OF THE PRODUCT
Cordless grass trimmer is used for decorative forming of lawns, by using a plastic line, which is rotating at high speed. Because of
the electric drive of grass trimmer its operation is much quieter than in the case of combustion tool, its operation is also possible in
vicinity of buildings. Due to the battery power supply, the grass trimmer allows you to work in areas, which are not accessible for to
mains-powered products. Correct, reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damages or injuries caused by the tool misuse, resulting from failure to comply with its designation, no compliance
with with safety regulations and recommendations included in this manual, the supplier does not accept any liability. The tool
misuse causes also the loss of user's rights to the guarantee and warranty.
PRODUCT EQUIPMENT
The grass trimmer is delivered in a complete state, but before its first use it requires to be assembled.
Along with the grass trimmer there are supplied:
- cover of the cutting element
- battery
- charging station

TECHNICAL DATA

Parameter
Catalog number
Rated voltage
Cutting speed
The length of cutting
Cutting line diameter
Length of cutting line on the spool
Electric protection class
Weight
Noise level
- L (pressure)
pA
- L (power)
wA
Vibrations
Type of the battery
Capacity of the battery
Energy of the battery
Charging station
Input voltage
Mains frequency
Rated power
Output voltage
Input current
Time of charging
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
O R I G I N A L
GB
Unit
[V]
[min ]
-1
[mm]
[mm]
[m]
[kg]
[dB (A)]
[dB (A)]
[m/s ]
2
[mAh]
[Wh]
[V]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
79510
18 DC
8000
230
1.3
2.5
III
2.4
72.4 ± 3.0
87.37 ± 3.0
1.45 ± 1.5
Li-ION
1500
27
230~
50
15
22.7 D.C.
0.38
5
13