Speedlink RACING SPHERES Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Separate the two halves of the ball casing by unscrewing it, and make
sure that the internal motor unit is powered off (switch set to OFF).
Using a screwdriver (PH0) loosen the screw on the motor unit's
battery compartment and insert the batteries (3 × AAA alkaline,
not included), making sure you insert them in accordance with the
polarity markings. Replace the battery compartment cover.
Repeat the process for the remote (2 × AAA alkaline, not included).
Leave both controls in mid-position. Power on the ball's motor unit and
the remote (set switches to ON). The connection is established as soon
as the ball's white LED and the remote's red LED glow solidly.
Note: If you intend to use multiple balls at the same time, power
on and connect each one individually, not simultaneously.
Screw the ball casing together again. If needed (such as if you
intend to use the ball on sandy surfaces or, for short periods of
time, water), position the silicone skin over the ball so that the join
between the two halves of the casing is completely covered.
Use the controller to control the ball. The white LED indicates the
To alter the ball's maximum speed, press the two buttons beneath
the right-hand controller simultaneously. One LED flash indicates
low speed, two flashes indicates high speed.
EN
1.
2.
3.
4.
5.
6.
direction of travel.
7.

Publicidad

Tabla de contenido
loading

Tabla de contenido