Troubleshooting - Scheppach TIGER 2500 Manual De Instrucciones

16. Troubleshooting

Problem Possible cause
Engine does not Engine, cable or connector defective,
run. fuses burnt.
The engine starts Voltage too low, coils damaged,
slowly and does not capacitor burnt.
reach the operating
speed.
Engine producing Coils damaged, motor defective.
excessive noise.
Engine does not Circuits in the network are overloaded
reach full power. (lamps, other engines, etc.)
Motor overheats Overloading of the engine, insufficient
easily. cooling of the engine.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Have the machine checked by a specialist. Never repair
the engine yourself. Attention! Check the fuses and
replace them if necessary.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the same
circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum engine
cooling.
GB | 25