Econo Cool Operation - Mitsubishi Electric MSZ-JP09WA Manual De Instrucciones

F
AN SPEED AND
AIRFLOW DIRECTION ADJUSTMENT
Press to select fan speed. Each press changes
fan speed in the following order:
(AUTO) (Low)
• Two short beeps are heard from the indoor unit when set to AUTO.
Press to select airfl ow direction. Each press
changes airfl ow direction in the following order:
(AUTO) (1) (2)
• Two short beeps are heard from the indoor unit when set to AUTO.
Airflow direction
(AUTO) .......... The vane is set to the most efficient airflow direction. COOL/
DRY:horizontal position. HEAT:position (5).
(Manual)......... For efficient air conditioning, select the upper position for COOL/
DRY, and the lower position for HEAT. If the position (4) or (5) is
selected during COOL/DRY, the vane automatically moves to the
upward position after 0.5 to 1 hour to prevent any condensation from
dripping.
(Swing)........... The vane moves up and down intermittently.
I To change the horizontal airfl ow direction.
Move the vertical vane manually before starting operation.
(Med.) (High) (Super High)
(3) (4) (5) (SWING)
E
CONO COOL OPERATION
Press during COOL mode
NO COOL operation.
The unit performs swing operation vertically in various cycle according
to the temperature of the airflow. Set temperature is set 4°F (2°C) higher
automatically.
Press again to cancel ECONO COOL operation.
• ECONO COOL operation also is cancelled when the VANE button is
pressed.
What is "ECONO COOL"?
Swing air fl ow (change of air fl ow) makes you feel cooler than constant air fl ow. So,
even though the set temperature is automatically set 4°F (2°C) higher, it is possible
to perform cooling operation with keeping comfort. As a result, energy can be saved.
T
IMER OPERATION (ON/OFF TIMER)
1
Press during operation to set the timer.
Each press changes timer mode in the following order:
(OFF TIMER) (ON TIMER)
2
Press to set the time of timer.
Each press increases or decreases the set time by 1 hour.
Press until "TIMER RELEASE" is selected to
release timer.
Note:
• ON and OFF timers can not be used in combination.
• If power failure occurs while ON/OFF timer is set, see
function".
page 5 to start ECO-
TIMER
RELEASE
page 5 "Auto restart
En-6