DeWalt D26430 Manual Del Usuario página 27

2 . Place the sanding sheet (5) directly on top of
the sanding pad.
3 . Hold the sanding pad with one hand and align
the dust extraction holes.
4 . Press the sheet firmly onto the sanding pad.
Rotating the Sanding Pad (fi g. A)
The sanding pad is adjustable in 60° increments.
1. Hold the tool upside down.
2. Lift the sanding pad (3) up from the tool.
3 . At the same time, rotate the sanding pad in the
desired direction.
4 . Release the sanding pad.
5 . Move the sanding pad back and forth slightly
untile it engages in position.
Mounting the Louvre Attachment
(fi g. C)
Fitted with sanding sheets on both sides, the louvre
attachment is used to sand crevices. The louvre
attachment is available as an option.
1. Place the tool on a table, sanding pad (3) up.
2. Loosen the screw (7) and remove it using the hex
key provided.
3 . Remove the spring (8) from the recess in the
sanding pad.
4 . Remove the sanding pad.
5 . Locate the louvre attachment (9) so that it
engages in position and cannot be turned.
6 . Place the spring (8) in the recess.
7 . Fit the screw (7) and tighten it.
Setting the Electronic
Speed Control Dial (fi g. D)
The speed is infinitely variable from 14,000–
22,000 min using the electronic speed control
-1
dial (2).
1 . Turn the electronic speed control dial to the
required level. The correct setting, however, is a
matter of experience.
2 . Generally, harder materials require a higher
setting.
Dust Extraction (fi g. E–G)
WARNING: Since woodworking with a
sander produces dust, always install a
dustbag designed in compliance with
the applicable directives regarding dust
emission.
WARNING: Do not use a dustbag or
vacuum extractor without proper spark
protection when sanding metal.
1. Slide a dust filter (10) into the cassette (4) as
shown.
2. Fit the cover (11) onto the cassette.
3. Attach the cassette (4) to the dust extraction
outlet (12).
4. Push the cassette firmly until it locks in position.
Fitting the Dust Extraction Adaptor
(fi g. G)
The dust extraction adaptor (13) is available as an
option.
1. Remove the dust filter cassette, if fitted.
2. Attach the adaptor (13) to the dust extraction
outlet (12).
3 . Pass the screw (14) through the adaptor outlet
(15) into the mounting hole (16). Tighten the
screw.
4 . Connect the hose of a suitable dust extraction
system to the adaptor.
5 . Alternatively, when no dust extration is required,
place the end cap (17) on the adaptor outlet
(15).
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Make sure all materials to be sanded
are well secured.
• Apply only a gentle pressure to the
workpiece. Excessive pressure does
not improve the sanding effect, but
only results in an increased load on
the machine and causes the abrasive
to tear.
• Avoid overloading.
WARNING: Do not sand magnesium!
EN GL IS H
25