Optional Accessories; Protecting The Environment - DeWalt D26430 Manual Del Usuario

EN GLI SH
Proper Hand Position (fi g. H)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand positioned
on the sander as shown in figure H.
Switching On and Off (fi g. A)
• Switching on: press the on/off switch (1).
• Switching off: press the on/off switch again.
Sanding (fi g. A)
• Start with the coarsest grit size.
• As the tool produces small scratch marks in all
directions, it is not necessary to sand with the
grain.
• Check your work at short intervals.
• Always switch off the tool when work is finished
and before unplugging.
Replacing the Dust Filter (fi g. E, F)
For efficient dust extraction replace the dustbag
when it is about one third full.
1. Press the latch (18) on the dust filter cassette (4)
2. Pull the dust filter cassette backward and off the
tool.
3 . Empty the cassette into a waste container.
4 . Remove the cover (11) from the cassette.
5 . Slide the dust filter (10) out.
6 . Fit a new dust filter following the instructions as
described above.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-ups
or when making repairs. Be sure the
trigger switch is in the OFF position. An
accidental start-up can cause injury.
26
Lubrication
Your power tool requires no additional lubrication.
• After the tool is used in metal sanding
applications without dustbag, clean the tool
using low-pressure air.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
WALT, have
E
WALT product
E