Repairing Air Supply Leaks; Storage - Tippmann Triumph XL Manual Del Usuario

Assembly (continued from page 19)
TO ASSEMBLE THE MID-GRIP HALVES ONTO THE RECEIVER
1) Make sure square nut
E
2) Place top of right Mid-grip half
bottom to fit flush onto Tank Adapter lug/pin
N
3) Guide top of left Mid-Grip half onto left side of receiver so the gas line
G
fits inside and the bottom fits onto adapter lug-pin
Right Mid-Grip half . Insert and tighten 4 screws
L
4) Insert and tighten 2 bolts
I
S
H
is in place in right Mid-Grip half
onto right side of receiver and align
.
and it aligns flush onto
.
/ . Mid-Grip installation is complete.
Bolt = 1 1/16"
Bolt = 7/8"
Bolt = 5/8"
Bolt = 1/2" Flat Head
Bolt = 1/2" Round Head
Screw = 1/2" + Head
20
Receiver Assembly (continued on page 21)
Assembly (continued from page 20)
:
TO INSERT AND ATTACH THE GRIP FRAME
.
TO THE RECEIVER and THE TANK ADAPTER:
1) Insert the front end of the Grip Frame
receiver and align it to fit onto the lug
tilt it side to side as you work it up into place until it fits
flush on the receiver.
Insert bolt
receiver and tighten.
Insert bottom of trigger guard
and position top of trigger guard so you can insert
bolt through it into the receiver and tighten.
2) Align Tank Adapter
2 tank adapter bolts
3) Install Battery Cover
attached to receiver
insert Battery Cover Bolt
Install Receiver Cover
Front Grip Cover guides align with guides on Receiver and cover fits flush.
Start 2 screws
Install Front Grip cover
it into position, start round head bolt
Install Barrel
and turn clockwise until snug.
Install the Hopper and
Repairing Air Supply Cylinder Leaks
The most common leak occurs from a bad air supply valve o-ring. To replace
a valve o-ring you must first remove the bad o-ring and then install a new
one. This o-ring is located on the tip of your air supply valve. The best valve
o-rings are made of urethane. The urethane o-rings are not affected by high
air supply pressures. These may be purchased from Tippmann
local paintball dealer. NOTE: If new valve o-ring does not resolve air supply
leak, do not attempt to repair air supply cylinder. Contact Tippmann Sports,
LLC or your local paintball dealer.

Storage

Before storage unload and remove air supply (see page 13). Then install
Barrel Sleeve (see page 2) and put your marker in Safe Mode (see page 4).
You should store your marker in a dry area. Before storing your marker
make sure that the marker is cleaned and oiled (see cleaning and
maintenance on page 13) so that it does not rust. Store your marker with
the bolt in the forward position
When removing your marker out of storage make sure Barrel Sleeve is
installed (see page 2) and safety is in Safe Mode (see page 4). You should
oil the rear bolt and the front bolt o-ring if needed before use.
into the
, then carefully
through back of grip frame, into
into grip frame,
to Grip Frame, insert
and tighten.
: with Grip-Frame
insert Battery Cover into position,
and tighten. Grip Frame installation is complete.
: Spread and slide the cover into place until
/ (one on each side) and tighten.
(or Front Grip on models XT or eXT): Slide
and tighten.
: Oil the barrel o-ring and insert the barrel into the receiver
adjust the velocity (see instructions on page 7).
, uncocked.
21
E
N
G
L
I
S
H
® or your