Hotpoint Ariston LL 40 Manual De Instrucciones página 6

1. Open the water inlet valve.
2. Press the ON/OFF button: the machine will emit a
beep and the ON/OFF indicator light will illuminate.
3. Open the door and measure out a suitable amount
of detergent (see below) .
4. Load the racks (see Loading the racks) and shut
the door.
5. Select the wash cycle by pressing the SELECT
WASH CYCLE button: the corresponding indicator
light will illuminate.
6. Select the wash options (see below) .
7. Start the cycle by pressing the START/RESET
button: the machine will emit a confirmation beep.
The WASH CYCLE PHASE indicator lights display
the status of the cycle:
Pre-wash, Wash, Rinse, or Drying.
8. At the end of the cycle two short beeps will sound
and the DRYING indicator light will flash. Switch off
the appliance by pressing the ON/OFF button and
close the water inlet valve.
9. Open the door and wait for a few minutes before
removing the crockery inside, in order to avoid
burns. Unload the racks, beginning with the lower
level.
If a mistake was made during the wash cycle
selection process it is possible to change the cycle,
provided that it has only just begun:press and hold
the START/RESET button for 5 seconds After one
long beep and three short beeps, the WASH CYCLE
PHASE indicator light will switch off: select the new
cycle and switch the machine back on by pressing
the START/RESET button.
Press the SELECT WASH CYCLE button:
The indicator light corresponding to the wash cycle
selected will illuminate.
Press the ON/OFF button and open the door, taking
care to avoid the escaping steam, and place the
crockery inside the dishwasher. Press the ON/OFF
button again: the cycle starts from the point at which
it was interrupted.
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts again
from the point at which it was interrupted once the
door has been shut or the electricity supply is
restored.
A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
compartment A compar compar tment A: Washing detergent tment A tment A
compar compar tment A
compar compar tment B tment B
compar compar compartment B tment B tment B: Pre-wash detergent
1. Open cover C by pressing
D
A
B button D.
2. Pour in the detergent after
consulting the Wash cycle
table :
• for powder detergent use
compartments A and B
• for tablets, when the cycle
requires 1 tablet, place it in
C
compartment A and close the cover; when it requires
2, place the second tablet at the bottom of the
appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
* Only available in selected models.