Moulinex LM6208FR Manual Del Usuario página 12

notice blender2:Mise en page 1
CLEANING
- Unplug the blender and remove the accessories.
- Wipe the motor unit (D) down with a damp
cloth. Dry carefully.
- Never plunge the motor unit (D) into running
water.
- Rinse the jug (E) under running water, along
with its accessories.
- To make the blender easier to clean (E), unlock
the blade holder (E1), remove the seal (E2),
remove the tap unit (F) before cleaning
everything.
WHAT TO DO IF MY BLENDER DOESN'T WORK?
Start by checking the power cord and plug,
then check:
- that the blender is properly set on the motor
unit.
- that the speed selection switch is in the right
position.
Your blender is leaking, check:
- that all the seals are properly positioned.
- the jug has not been overfilled above the
maximum level (1.25 litre)
RECYCLING
26/02/08 14:54
Play your part in protecting the environment!
Your appliance contains a lot of recoverable or recyclable material.
Leave it at a local civic waste collection point so that it can be recycled.
DISPOSAL OF THE PACKAGING OF THE APPLIANCE
The packaging does not contain any materials that are harmful to the
environment, they may all be disposed of in compliance with the
recycling rules in force.
For disposal of your appliance, please contact the appropriate municipal
department.
8
Page 8
Diagram ❼ :
Dismantling the tap (F) to make cleaning easier:
- Unscrew the body (F2) of the lever (F1),
holding the bolt tightly (F3).
To reassemble it, do the same operations in
reverse, making sure that the seal (F4) is fully
tightened.
- Handle the blades with extreme care, they
are very sharp.
- All the accessories are dishwasher-safe.
Your appliance still does not work?
Call our Customer Relations Helpline:
0845 602 1454 or
(01) 677 4003 - Ireland
or consult our website - www.moulinex.co.uk
You can customise your blender and obtain the
following accessories from your usual
retailer or an approved centre:
- Grinder accessory
- Ice stick
- cap (J)