Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Make sure the battery and receiver are installed firmly
and correctly for safe operation.
• This unit is for indoor use only. Avoid exposure to high
temperature sources, strong sunlight and moisture.
The receiver works best when used in a space with
good air circulation.
• Do not exceed the maximum load current of 10A
(approximately 1250W)
PROGRAMMING
Notes: The receiver is pre-programmed for
immediate use, but the configuration can be
customized to meet your needs.
To program the remote control and receiver:
1. Remove the receiver from the power socket, then
plug the receiver back into the power socket.
2. Press and hold the "learning and ON/OFF" button
until the indicator starts to flash.
3. Release the "learning and ON/OFF" button, press and
hold the corresponding "ON" button on the remote
until you hear a click.
4. The indicator will stop flashing indicating that pairing
is successful.
RESETTING THE RECEIVER
Should you wish to unpair a receiver from the remote
or if the unit is unresponsive, the receiver can be reset
following these steps:
Publicidad
Tabla de contenido
