Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the receiver from the power socket.
2. Press and hold the "learning and ON/OFF" button on
the receiver.
3. While still holding the button, plug the receiver back
into a power socket and wait to see the indicator to
flash.
4. When the indicator stops flashing, you may release
the button, and the reset process is now complete.
5. You may program the outlet after resetting.
TROUBLESHOOTING
In the case that the receiver does not respond to the
remote control, please follow these steps to solve
the issue:
1. Check to see if the battery of the remote is low and
needs replacement.
2. Make sure that the receiver is correctly placed in the
power socket.
3. Make sure that the receiver is used in an area with
proper air circulation to avoid overheating.
4. Reset and program the unit.
WARNING
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
Publicidad
Tabla de contenido
