GE RAS200 Manual Del Propietário página 20

Cleaning the Glass Cooktop (Cont.)
Heavy, Burned-On Residue
1. Allow the cooktop to cool.
a 45° angle against the glass surface and scrape the
soil. It will be necessary to apply pressure to the razor
scraper in order to remove the residue.
3. After scraping with the razor scraper, spread a few drops
Cleaning Pad to remove any remaining residue.
4. For additional protection, after all residue has been
removed, polish the entire surface with CERAMA
Ceramic Cooktop Cleaner and a paper towel.
®
Metal Marks and Scratches
cooktop. It will leave metal markings on the cooktop
surface.
These marks are removable using the CERAMA
Ceramic Cooktop Cleaner with the CERAMA
®
Cleaning Pad for Ceramic Cooktops.
®
Cooktop Seal
To clean the cooktop seal around the edges of the glass,
lay a wet cloth on it for a few minutes, then wipe clean
with nonabrasive cleaners.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
removing hot substances.
1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt:
®
spill to a cool area on the cooktop.
b. Remove the spill with paper towels.
20
Ceramic Cooktop Cleaner on the
®
®
all recommended supplies are available through our
section on next page.
NOTE:
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
3. Any remaining spillover should be left until the surface
of the cooktop has cooled.
residue has been completely removed.
NOTE: If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.
Ceramic Cooktop Scraper and
®
49-88073