Desoutter ELB pistol tools E-LIT PLUS Serie Manual De Instrucciones página 19

English
TWO REVERSE MODES
L
See page 11.
Legend
L1 Mode 1: one touch reverse (default)
L2 Mode 2: Permanent reverse
BATTERY CHECK
M
See page 11.
LOW BATTERY STATUS AFTER EACH
TIGHTENING
N
See page 11.
SPEED SETTING MODULE -V2
O
See page 12.
ZIGBEE® NETWORK CONNECTION
(FOR ELC-Z TOOLS)
P1
See page 14.
WIFI NETWORK CONNECTION
(FOR ELC-W TOOLS)
P2
See page 14.
SPECIFIC COMMUNICATION LED
(FOR ELC-* TOOLS)
Q
See page 15.
No communication to network.
See "P" page 14.
Tool locked.
Batch complete.
Preventive maintenance.
ELC-W SET UP
R
See page 16.
Legend
1 Plant network
2 Ethernet link
3 Battery nutrunner
Check you have the following equipment:
● ELC-W Battery nutrunner.
- Battery.
- Charger.
- e-DOCK device to connect the tool to the
PC.
● PC with an Open Protocol interface.
● Desoutter WIFI access point.
- Power cord.
10/2019
● Ethernet network.
● Ethernet cable (not supplied) to connect the
Wi-Fi access point to the PC.
● Standard PC connected to the Ethernet
network and equipped with the Desoutter
Elit Suite software to create and control the
tightening processes.
Before starting
Before starting the set up, check that you have
the following information on hand:
● WIFI access point
Parameters
IP address
Network name (SSID)
Security type
Encryption type
Security key
● ELC-W Battery Nutrunner
Parameters
IP address
● Plant network
Parameters
Communication port
Subnet Mask
Check with your local Desoutter representative
how to set up your specific system environment.
● To get the complete list of the configuration
by default, refer to the ELIT CONFIG
user manual at http://resource-center.
desouttertools.com.
Wi-Fi access point
● Contact your local Desoutter representative
for more information.
Battery nutrunner
When delivered, all battery nutrunners
are set with the same communication
parameters.
● Change the battery nutrunner IP
address and the communication port
to avoid settings issues.
● Insert the battery pack and plug the e-DOCK
as shown page 14.
● Connect the e-DOCK to the PC USB port. A
New serial port is created.
● Launch ELIT CONFIG software and select
"WIFI Tool" tab on the left top of the screen.
● Change the parameters according to your
installation.
19 / 134
6159933730_27
By default
192.168.5.201
Desoutter_1
WPA/WPA2PSK
AES/CCMP
mydesoutter_1
By default
192.168.5.221
By default
4545
255.255.0.0