General Safety Instructions - Sicce Voyager 2 Manual De Instrucciones

Dear client,
EN
thank for choosing VOYAGER 2-3-4, the new stream pump for salt
and fresh water aquariums. Made on the most recent technology with
a high reliability, minimum maintenance and low energy consumption
VOYAGER range has a compact design and a powerful adjustable revolving flow
at 360°. A strong magnetic support guarantees a perfect seal even to very dirty
aquarium glass. Please, read carefully and save the following instructions to use in
the best way your VOYAGER!

GENERAL SAFETY INSTRUCTIONS:

VOYAGER range are made in conformity with the national and international
security laws.
1) Always isolate the pump from the mains electricity before installing or carrying
out any maintenance. Power to the pump must be supplied through a Residual
Current Device (RCD) with a rated residual operating current not exceeding 30mA
2) This pump is designed to be used indoors and is not suitable for any outdoor
applications.
3) Before connecting the pump to the electricity supply, check there are any
damages on cord or plug.
4) The pump has a type Z cable link. The cable and the plug cannot be substituted
or repaired; in case of damages replace the entire pump.
5) ATTENTION: do not operate any appliance if it has a damaged cord or plug, if it
is malfunctioning, or if it has been dropped or damaged in any way.
6) Never operate the pump without water inside the impeller chamber or with liquids
at a temperature higher than 35° C / 95° F.
7) Do not use the pump with corrosive and abrasive liquids.
8) Do not use the pump for uses different (i.e. in bathroom or other applications) to
those for which it has been designed.
9) The pump cannot be used by people with handicaps or by children if they are not
supervised by a person responsible for their safety.
10) Avoid closeness with blades, sharp objects or other magnets to prevent
accidental injuries as the magnets of the support attract metal objects and other
magnets with high force.
11) The magnets can provoke permanent damages to electronic devices and to
other objects that are sensitive to magnetic field such as pacemakers, credit cards
and keys: always keep them at least 30 cm (12 inches) distance.
12) The magnets could loose partially or completely their attracting power if
exposed to temperature higher than 50° C / 122° F.
13) Always leave a drip-loop in the pump cable to prevent water running down the
cable and reaching the power source (Pic. A).
14) Avoid taking the pump by the cord during the installation or maintenance.
15) Do not try to attach directly the two magnets holder because the magnetic
attraction is very high. Hold them only on the external sides paying attention not to
put your hands or fingers in between.
PUMP INSTALLATION: USE AND REGULATION
ATTENTION: before make the product functioning, verify that it is complete with all
its parts. To install the pump, proceed as follows.
1) To avoid resonances and vibrations, do not put the pump in contact with the
lateral surfaces nearby or at the bottom of the tank to avoid sand or small stones
to be sucked by the pump.
2) To connect the magnetic support to the pump, insert the pump into the staple
overlapping the holes (Pic. 3a). Insert the handle in the staple in the holes (Pic. 3b),
screwing it in so to keep the pump in place.
3) Clean the glass and position the pump inside the tank, submerging it completely.
Pay attention that the upper part of the pump is positioned in the right way
otherwise, if the water level decrease, the pump could suck air and make noise.
4) Attach the external magnetic support to the tank at a 10 cm / 3.93 inches distance
from the centre of the internal support. Drag it until perceiving of the opposite
magnetic force and position the centres of the 2 supports on the same axis.
ATTENTION: Please follow carefully the above instruction because if the
installation in made differently, you may cause glass breakage and finger pinching
as the attraction power of the magnets is very strong.