ENGLISH
Display Identifier Code display: iD
It displays the code that identifies the regulator
Parameters setting: PAr
NOTE: during the parameters setting mode the regulator does not communicate on the serial communication
channel.
It is possible to vary the value of some parameters compared to the factory default.
Use the UP/DOWN keys to change the value and MOD to confirm to go to the next
parameter.
The parameters are:
P1: hours of operation before "dirty filter" signaling, filtro F7. The possible values are
"OFF" and a value in the range between 1 and 9000 h. (Default value: 8000 h);
P2: hours of operation before "dirty filter" signalling, pre-filter. The possible values are
"OFF" and a value in the range between 1 and 9000 h. (Default value: 4000 h)
P3: hours of operation before "dirty filter" signalling, filter H14. The possible values are
"OFF" and a value in the range between 1 and 9000 h. (Default value: 7305 h);
P4: Minimum fan speed voltage: value in the range between 0 and 5V. (Default value: 2V);
31