Gb Instructions For Use 6 Dk - Campingaz PARTY GRILL Instrucciones De Empleo

INSTRUCTIONS FOR USE
Consumption: 99 g/h (1.36 kW) - injector no. 015556
GB
Category: direct butane pressure.
Thank you for having chosen this Campingaz
A - IMPORTANT: YOU ARE USING GAS, TAKE
GREAT CARE !
These instructions are intended to help you to operate
your Campingaz
®
Read them carefully to familiarise yourself with the
equipment before connecting it to the gas cylinder.
Follow these instructions for use as well as the
safety instructions on the CV 470 / CV 270 / CV 300
Campingaz cartridges. Failure to follow these in-
®
struction may endanger the safety of the user and
any other persons in the vicinity.
Keep these instructions in a safe place so that you
can refer to them if necessary.
This equipment should be used only with Campin-
gaz CV 470 / CV 270 / CV 300 cartridges. It may be
®
dangerous to use other gas cylinders.
The Application des Gaz Company declines all re-
sponsibility if another brand of cartridge is used.
This equipment must be used only in areas that are
properly ventilated (minimum 2 m
from inflammable material.
Do not use an appliance which is leaking, not operat-
ing correctly or worn. Take it to your retailer who will
give you details of your nearest After Sales Service.
Never modify the equipment or use it for any pur-
pose for which it is not intended.
Do not use this product in caravans, cars, tents,
huts, sheds or any small enclosed areas.
The product should not be used while sleeping or
left unattended.
This product consumes fuel through combustion or
consumption of oxygen and gives off certain sub-
stances and gas, which could be dangerous such as
carbon monoxide (CO).
Carbon monoxide is an odorless, clear gas that can
cause flu-like symptoms, sickness, illness, and pos-
sibly death if produced inside aforesaid enclosed
areas through use of the product without proper
ventilation.
B - ASSEMBLING YOUR CAMPINGAZ
GRILL STOVE
a) Remove the stove from its packing, remove the lid (2),
the hot-plate (3) and the pan supports : cross-pieces (4)
(fig. 2)
b) Remove the legs (8) turn the stove upside down and
fit them into the slots; push the legs until they click into
place (fig. 4)
c) Make sure that the water reservoir (5) is connected cor-
rectly. Turn the reservoir until it arrives at the arrow "v"
(fig. 3).
d) Ensure that the burner (6) is mounted correctly (fig. 3)
e) Place the stove on a firm, horizontal surface. For use in
other circumstances, see paragraph H.
®
Party Grill.
/h/kw) and away
3
C- FITTING A CAMPINGAZ
CV300 CARTRIDGE
(If there is already an empty cartridge, read paragraph G,
Party Grill. "Removing the cartridge").
To fit or remove a cartridge, always work in a well
ventilated area, preferably outdoors, away from other
people and inflammable material, never near a naked
flame, heat or spark source (cigarettes, electrical equip-
ment, etc).
AS CAMPINGAZ
ES HAVE VALVES, EVEN IF THEY ARE NOT EMPTY,
THEY MAY BE REMOVED FROM THIS EQUIPMENT
TO MAKE IT EASIER TO TRANSPORT, AND THEY
MAY BE FITTED TO OTHER EQUIPMENT FROM
THE CAMPINGAZ
DESIGNED TO
THESE CARTRIDGES.
a) Ensure that the gas inlet is in the closed position turn the
knob (7) clockwise to the arrow.
b) Turn the appliance upside down.
c) Align the lever of the 'easy clic' system (1) with the arrow
(f) and rotate until it stops (C) without forcing it.
d) Attach the cartridge to the Party Grill as indicated (a) and
(b), clicking firmly into place (checking the right clip effect
it should remain in place ).
e) Return the 'easy clic' lever (1) to the stop mark(d) as in-
dicated (fig. 6) and return the Party Grill to an upright
position.
If there is a gas leak (you can smell gas before open-
ing the tap) immediately take the unit outside, to a very
well ventilated place which is free of sources of gas ig-
nition, where the leak might be located and stopped.
If you want to test for leaks, do so outside. Do not test for
leaks with a flame, but use gas leak solution.
D - PREPARING THE PARTY GRILL FOR USE AS
A "HOT-PLATE"
a) Fill the reservoir with 3/4 of a litre of water (5). The lev-
el should be a few milimetres under the central tube:
(fig. 3) mark "n"
b) Place the hot-plate (3) onto the support according to the
index marks (4).
E - USING THE PARTY GRILL AS A "HOT-
PLATE" (FIG. 9/a)
PARTY
®
a) Lighting the burner
1) Open the tap by turning it (7) anti-clockwise: 1 rotation
maximum.
2) Press the button (7) with the thumb until the piezo sys-
tem operates. This is made easy if the other fingers
are placed in the slot provided. (fig. 8)
3) If the burner flame is not visible under the hot-plate,
(fig. 8), recommence the procedure "b".
4) After 3 attempts, close the tap by turning it clockwise
as far as it will go. Check that the cartridge contains
gas and start the lighting operations a) and b) again.
b) Pre-heating
Pre-heat the hot-plate for one minute at maximum in or-
der to reach the ideal temperature for cooking.
6
CV 470 / CV 270 /
®
CV 470 / CV 270 / CV 300 CARTRIDG-
®
470/270/300 RANGE WHICH ARE
®
OPERATE EXCLUSIVELY WITH