Overhead Rigging - JB Systems Light RS 40 Manual De Instrucciones

ENGLISH
FUNCTIONS
(FRONT)
The RS40 is a 4-channel light modulator. This means the preprogrammed chases can
switch lamps ON/OFF to the music or with selected speed ( Static mode ):

Music mode: set the audio knob (number 2) to the preferred value to determine
the reaction to the music.

Static mode (The Audio knob is turned to zero): The lamps will follow the
selected chase at a speed that you can select with the speed knob (number 3)
IMPORTANT ! When both knobs (audio knob and speed knob) aren't set to zero, the
lamps will react to the music (when there is sound). When there is no music, the lamps
will automatically follow the selected chase with the speed that is selected on the speed
knob
1. POWER SWITCH: Used to turn the unit ON/OFF.
2. AUDIO KNOB: With this knob, you set the sensitivity of the internal micro.
3. SPEED KNOB: With this knob, you set the speed of the lamps when they are not working in music
mode.
4. DIP SWITCHES: With these 2
switches, you select the desired
chase sequence.
JB SYSTEMS® 3/30
OPERATION MANUAL
RS40
ENGLISH
5. CHANNEL LEDS:

LED ON: output is ON

LED OFF: output is OFF
FUNCTIONS
(REAR)
6. HANGING BRACKET: with 2 handles on both sides to fasten the unit and a mounting hole to fix a
mounting hook.
7. CHANNEL OUTPUTS: These outputs are equipped with IEC sockets.
8. MAINS CABLE

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
JB SYSTEMS® 4/30
OPERATION MANUAL
RS40