Axis Q6055-C Guia De Instalacion página 27

AXIS Q6055-C PTZ Dome Network Camera
RX+
3 – green/white
4 – green
RX-
TX+
5 – orange/white
6 – orange
TX-
8 – black
0 V DC (-)
DC output 1, 9 – red
(24 V)
Media converter switch connectors
NO TICE TICE
NO NO TICE
The product shall be connected using a shielded network cable (STP) or an optical fiber
cable. All cables connecting the product to the network shall be intended for their
specific use. Make sure that the network devices are installed in accordance with
the manufacturer's instructions. For information about regulatory requirements, see
Electromagnetic compatibility (EMC) 2.
Important
The media converter switch does not support hotswapping. Disconnect power from the
switch before swapping cameras. An attempt to hotswap could cause the switch to freeze,
in which case it must be restarted.
Camera connectors
Power connector
Two 2-pin terminal blocks for power output (pin 4
is not used).
Function
DC 24 V DC
output
0 V DC (-)
N/A
Ethernet – receiving
Ethernet – receiving
Ethernet – transmitting
Ethernet – transmitting
Used to power camera
Pin Notes
1, 2
Power out to camera
3
4
N/A
27
0 V DC
24 V DC