Elu After-Sales Service - Elu BSA34 Manual De Instrucciones

E N G L I S H
Switching on and off (fig. A & D)
• To run the tool, press the variable speed switch (1).
The pressure exerted on the variable speed switch
determines the tool speed.
• To stop the tool, release the switch.
• To lock the tool in off position, move the forward/
reverse slider (2) to the central position.
The drill is equipped with a brake to stop
the tool as soon as the variable speed
switch is fully released.
Screwdriving (fig. A)
• Select forward or reverse rotation using the slider (2).
• Set the collar (4) to position 1 and begin
screwdriving (low torque).
• If the clutch ratchets too soon, adjust the collar
to increase the torque as required.
Drilling (fig. A)
• Select the drilling mode using the collar (4).
Drilling in metal
• Use a cutting lubricant when drilling metals.
The exceptions are cast iron and brass which
should be drilled dry.
Drilling in wood
• Holes in wood can be made with the same twist
drills used for metal. These bits may overheat
unless pulled out frequently to clear chips from
the flutes.
• For larger holes use Auger bits.
• Use a block of wood to back up workpieces that
may splinter.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your Elu Power Tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
en - 6
Lubrication
Your tool requires no additional lubrication.
Cleaning
• Unplug the charger before cleaning the housing
with a soft cloth.
• Remove the battery pack before cleaning your
Power Tool.
• Keep the ventilation slots clear and regularly
clean the housing with a soft cloth.
Environment
Rechargeable battery pack
This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely,
then remove it from the tool.
• NiCd and NiMH cells are recyclable. Take them
to your dealer or a local recycling station.
The collected battery packs will be recycled or
disposed of properly.
Unwanted tools
Take your tool to an Elu authorised repair agent
where it will be disposed of in an environmentally
safe way.

Elu After-Sales service

All Elu Power Tools are thoroughly tested before
leaving the factory. However, if the Power Tool
needs repair, please contact your dealer or the Elu
Head Office for the address of the nearest Elu
authorized repair agent (please refer to the back of
this manual). Alternatively, a list of authorized Elu
repair agents and full details on our after-sales
service are available on the Internet at
www.2helpu.com.
21