Dremel 3D45 Instrucciones De Funcionamiento Y Seguridad página 24

DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 24
24
FIG. 2
4. Remove Spool door by rotating it counter
clockwise, see figure 1. Remove existing
spool if one is present.
5. Thread tip of new filament through guide
tube, place spool on spool holder, replace
spool door by aligning locking tabs and
rotating clockwise, see figure 1.
6. When you place a roll of Dremel filament
into the spool holder, the printer will auto-
recognize the filament type and adjust the
printer settings to be optimized for the
filament you are using (This will bypass any
print settings loaded in your sliced file).
NOTE: You have the option to enter
advanced printer mode to manually alter
print settings after you change filament.
Please check all settings (if manually
entered) as improper settings may cause
prints to fail or damage the equipment,
see "Filament Type and Settings" or on
digilab.dremel.com for the latest chart.
Getting Ready to Build
Filament
Guide Tube
NOTE: You also have the option to pull
print settings from the saved sliced file.
This will prevent the printer from altering
its print settings. Please check all settings
prior to printing as improper settings may
cause prints to fail, property damage, or
personal injury.
7. If changing existing filament, 3D45 will
automatically purge existing filament.
8. When Feed Filament screen appears, tap
the arrow on touch screen and thread
filament coming from guide tube into
extruder intake until filament feeds
through on its own, see figure 2.
NOTE: Ensure the gears inside of the
extruder have properly grabbed the
filament before you finish the filament
change. You will feel a tug and see the
filament start to feed itself into the
extruder when this occurs.
Filament Extruder
Guide Intake