Dremel 3D45 Instrucciones De Funcionamiento Y Seguridad página 36

DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 36
36
PROBLEM
3D45 will not connect to my
network.
3D45 will not retrieve a token.
Cloud slicer will not connect to
3D45 or shows "printer offline".
Token invalid.
Build did not start when sent
over network.
Troubleshooting
CAUSE
Printer too far from wireless
router.
Network password or SSID
incorrect
Network password incorrect.
Network has a firewall.
3D45 not connected to network.
Verify the current 3D45 token
using "Tools/About" and retry.
Filament ran out.
Doors open.
Model was already building
CORRECTIVE ACTION
Reposition 3D45 to be closer to your
router.
Re-enter your password/SSID or
verify your password with your
network owner.
Re-enter your password or verify
your password with your network
owner.
Enter network proxy information.
Check 3D45 network settings and
retry connection.
Use "Get new token" to generate a
new token and retry connection.
Note this will remove any users that
are sharing your printer.
Load additional filament and resume
build.
Doors must be closed to start builds
over your network, start build from
print queue.
The build plate must be clear to start
a build over your network, clear the
build plate and start build from print
queue.