Fcc Compliance; Information On Intellectual Property - Dremel 3D45 Instrucciones De Funcionamiento Y Seguridad

DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 6
6

FCC COMPLIANCE

NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
The Dremel 3D45 is intended for 3D printing
objects from digital files that you create or
own, or have the right to print using the
Dremel 3D45. When making objects using
the Dremel 3D45, it is your responsibility to
ensure that you do not infringe any third
party intellectual property rights or violate
any applicable laws or regulations, such as
U.S. or foreign intellectual property laws.
The Dremel 3D45 may not be used to make
objects protected by intellectual property
rights owned by third parties without such
third parties' permission. Using the Dremel
3D45 to do any of the following may require
the permission of third parties: to make a
duplicate or facsimile (in whole or in part) of
any object not created by you, to make an
object from a digital file you do not own, or to
make an object from a scan of a physical
object that you did not create. It is your
responsibility to obtain such permission. In
FCC and IC Compliance

Information on Intellectual Property

• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes and Modifications not expressly
approved by the manufacturer or registrant of
this equipment can void your authority to
operate this equipment under Federal
Communications Commission's rules.
some cases, you may not be able to obtain
such permission. Where such permission
cannot be obtained, you should not 3D print
such object, or you do so at your own risk.
You may not modify, reverse engineer,
decompile, or disassemble the Dremel 3D45
or its software or firmware, except as
permitted by applicable law.
If you use the Dremel 3D45 in any way other
than as recommended and described in
these Operating/Safety Instructions, you do
so at your own risk. Using the Dremel 3D45
to make objects that infringe any intellectual
property rights owned by third parties could
result in civil or criminal prosecution and
penalties, and you could be liable for money
damages, fines, or imprisonment.