VWR 10048-618 Manual Del Usuario página 3

Model 10048-688/620-2208 – Supplied with 1 bottle probe with cable and 1 standard plastic probe
with cable.
Model 10048-644/10048-646; 620-2209/620-2210-- Supplied with 1 stainless-steel probe (6435) or 2
stainless-steel probes (6436) triple-purpose probe for liquids, air/gas, and semisolids. Accurate
readings with tip penetration of
overall length of 9 inches and a cable length of 5 feet.
SETTING THE TIME-OF-DAY/DATE
1. Slide the DISPLAY switch to the DATE/TIME position, the thermometer will display the time-of-day
and date.
Adjustable parameters are Year->Month->Day->Hour->Minute->12/24 hour time.
2. Press the SELECT button to enter the setting mode.
3. Subsequently press the SELECT button to select which parameter to adjust. The selected
parameter will flash once selected.
4. Press the ADVANCE button to increment the selected parameter.
5. Hold the ADVANCE button to continuously "roll" the selected parameter.
6. Press the EVENT DISPLAY button to toggle between Month/Day (M/D) and Day/Month (D/M)
display modes.
If no button is pressed for 15 seconds while in the setting mode, the thermometer will exit the setting
mode.
Changing the position of the DISPLAY switch while in the setting mode will save the current settings.
VIEWING THE TIME-OF-DAY/DATE
To view the time-of-day/date, slide the DISPLAY switch to the DATE/TIME position.
SELECTING THE UNIT OF MEASURE
To select the desired unit of temperature measure (°C or °F), slide the UNITS switch to the
corresponding position.
SELECTING THE TEMPERATURE PROBE CHANNEL
Slide the PROBE switch to either position '1' or position '2' to select the corresponding probe channel
P1 or P2.
All temperature readings displayed will correspond with the selected probe channel.
Note: Both probe channels are sampled and monitored continuously regardless of the selected
probe channel.
MINIMUM AND MAXIMUM MEMORY
The minimum temperature stored in memory is the minimum temperature measured since the last
clear of min/max memory. The maximum temperature stored in memory is the maximum
temperature measured since the last clear of min/max memory.
MINIMUM AND MAXIMUM TEMPERATURE VALUES ARE NOT PROGRAMMABLE.
Minimum and maximum temperature values are stored individually for each probe channel P1 and
P2. Both channels are monitored continuously regardless of the selected probe channel.
VIEWING MIN/MAX MEMORY
-inch. Probe has a diameter of ⅛-inch, stem length of 6¼ inches,
1
/
3
VWR Collection Manual ver 3, rel 5 30.10.2013