Important - Avidsen 100771 Manual De Instrucciones

D - CONFIGURATION
Press the settings icon
settings:
1
Camera information: name, fi rmware version, etc.
2
Confi guring the date, hour and time zone
3
Confi guring the video format: PAL / NTSC,
Movement detection, reversing the image (for a
reversed image ceiling installation) Setting the
camera's speaker volume
4
Allows the password to be changed and guest
password to be confi gured
5
Not used on this model
6
Allows access to another WiFi network to be
confi gured. If an error occurs, you will have to reset
the camera.
7
Confi guring alarm, siren activation time, the
camera's integrated infrared movement detector,
Push notifi cations and email confi guration settings
8
Confi guring the type of recordings the camera takes
on a microSD card (not included): programming /
upon alarm / upon request
9
Confi guring and Adding/Removing accessories
(remote controls, detectors, etc.) to/from the alarm
kit
10
Allows the camera to be updated if new Firmware
is available
9. Pairing accessories with the camera:
Press the settings icon
settings:
12
EN
to display the camera's
1
2
3
4
5
6
7
8
9
10
to display the camera's
WIRELESS ALARM KIT
Press "ajouter un capteur" [add a sensor]
• To pair a remote control, press "+" to the right of
"Télécommande" [remote control]. Next, click on
"ok / confi rmer" [OK/Confi rm]" and then hold down
the disarm key (open padlock symbol on the top
right) on your remote control while you wait.
• To pair an opening detector or movement
detector, press "+" to the right of "Capteur"
[sensor]. Then press "ok / confi rmer" [OK/Confi rm].
Meanwhile, position the magnet close to the marker
on the side of the detector (the red light on the
detector will come on) or activate the movement
detector by sliding the ON/OFF button to the "OFF"
position and then the "ON" position.

Important:

• You can activate or deactivate a specifi c sensor
by sliding the blue toggle switch
• You can rename a sensor or remote control once
it has been added by pressing on the name once
• You can assign an automatic camera motion (pre-
confi gured position from the live video) to the
triggering of a sensor by pressing the
"TrackEye" function
• You can delete a sensor or remote control by
pressing and holding it for more than 3 seconds on
Android or by swiping it to the left on iOS
10. Confi guring your Alarm
Press the settings icon
settings:
Press "Confi guration
confi guration] :
.
:
icon:
to display the camera's
d'alarme" [Alarm
1
2
3
4
5
6