Wiring; Important; Initial Set-Up - Velux Integra KUX 110 Manual De Instrucciones

Wiring

B
Lead the connecting cable from the power supply unit to the
window. Wiring in roof windows is described in the instructions
for wiring supplied.
The 8 m long cable has a cable cross-section of 2 x 0.75 mm
If necessary, it can be extended by up to 12 m using the same
cable type (max total length: 20 m). If the cable must be longer
than 20 m, the cable supplied must be replaced by a cable with
a cable cross-section of 2 x 1.50 mm
Connecting products to a power supply unit
When connecting more than one product, lead the cable to
a junction box from where the cables are distributed to the
individual products. The junction box should be placed as close
as possible to the products to be supplied with power.
Connecting products to additional power supply
units
When installing more than one power supply unit, use a
separate 2-core cable for each power supply unit. Do not use
multicore cables as the signals between the power supply units
and connected products may be disturbed.

Important

The polarity (+/-) must be kept all the way through to the
product.
7 VELUX ®
.
2
(max total length: 50 m).
2
ENGLISH

Initial set-up

C
Before starting the initial set-up, the product to be supplied
with power must be fitted to the window and connected to the
power supply unit.
The next three steps must be completed within
10 minutes.
1. Connect power supply unit to mains supply.
2. Remove strip from remote control supplied.
3. Press RESET button (for 1 second) on the back of the remote
control with a pointed object.
The product can now be operated.
Note: If the 10 minutes are exceeded, disconnect from mains
supply and start all over again.
Note: If you have more than one power supply unit, you must
finish the initial set-up for one power supply unit at a time.
ENGLISH
VELUX ® 8