Product Operation - Marshalltown TC17 Manual Del Usuario

• Be sure to place the cutter on a flat and even surface when in use.
• Do not exert too much force on the cutter or tiles as this will cause tiles to break.
• After you cut tiles, be alert that the newly cut edge can be sharp.
To cut a straight line:
1. Place tile on base and slide until flush against the
guide. Adjust the square guide to desired position.
3. After scoring, and without moving the tile, position
the handle so that the breaker foot is directly above
the tiles front edge (at the stop).
WS2769
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

2. Place the cutting wheel on the rear edge of the tile
and slide the wheel forward by pushing the handle
down, scoring the tile as the handle is pushed
forward. It is important to make this scoring cut in
one continuous motion, scoring only once per tile.
4. Apply increasing downward pressure on handle
until the tile snaps.
5 of 8