Product Operation - Marshalltown Bullet 526-RCT26 Manual De Instrucciones

1. While gently pushing handle
down, pull Safety Lock pin out,
then lift handle.
Your Soft Flooring EZ Shear cuts a wide variety of products. Please refer to page 2 for recommended products
and thicknesses.
Note: Even the approved materials may vary greatly in density and hardness. If extreme force is required to cut
a material stop immediately, as it could lead to damage to your shear or injury. Attempting to cut unapproved
materials will void the warranty.
FINE TUNE YOUR FENCE
The fence on Soft Flooring EZ Shear is adjustable to 1/2 degree
in either direction of square. To make fine adjustments:
1. Loosen (but do not remove) the three Phillips screws
which secure the fence.
2. Rotate the fence to the desired angle.
3. Re-tighten the three Phillips screws.
WS2638
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

2. Place product on table. It is
recommended that you HOLD
YOUR MATERIAL IN PLACE until
the cut is complete. Bring handle
down until blade touches material.
3. Push handle down until the
material is completely cut.
7 of 14